Mitering an ICF Ledge Corner V
August 5th, 2010 | Common Troubleshooting, From the Field | Darryl U, ICF Construction, Ledge Form, mitering a ledge form, xLerator
OK we have walked through all of the steps necessary for cutting a 90 degree corner out of an insulating concrete form ledge. To finalize this tutorial below are the steps to cut the inside corner ledge.
ICF Construction- Inside Ledge Corner
Line up the ties and allow for room to make a cut
Draw 45 degree angle from the ledge and draw cut lines
Make the Cut
For the perpendicular Ledge Form that will connect the corner- measure the 45 degree to the outside corner apex. Next, make a square cross cut on the outside panel at the inside core wall.
Once corner is cut you will have to remove the teeth directly in the corner, so a 90 degree can fit snugly on top.
No need to dig out the corbel or bend xLerator as concrete will flow correctly and ledge will be properly reinforced
And Congratulations you have completed the Mitering an ICF Ledge Corner Tutorial. If you have any questions leave us a comment or give us a call!
